iStick Pico RESIN

Product Introduction:

This new RESIN style iStick Pico features a durable resin encasement of light weight, nice looking and comfortable texture, and each one comes in its unique psychedelic pattern. The innovative process and compact size make it comfortable to hold and carry. Powered by single interchangeable 18650 cell, the iStick Pico provides you with 75W maximum output and upgradeable firmware.

Parameter:

• Weight: 75g
• Size: 45mm*23mm*70.5mm
• Thread type: 510 thread
• Cell type: High-rate 18650 cell
  (Continuous discharge current should be above 25A)
• Output mode: VW/Bypass/TC(Ni,Ti,SS,TCR-M1,M2,M3) mode
  Output wattage: 1-75W
• Resistance range: 0.05-1.5ohm (TC modes)
• Resistance range:0.1-3.5ohm (VW/Bypass mode)
• Temperature range: 100－315℃/200－600℉ (TC modes)

Standard configuration:

• 1×iStick Pico (without cell)
• 1×USB Cable    1×User Manual   

Compact, Lightweight, Durable, and Comfortable to Use

This new RESIN style iStick Pico features an encasement of resin material which is scratch-resistant, durable and lightweight. Also with a compact size, you can hold the iStick Pico RESIN style in the palm or put in pocket, much more comfortable to use and carry.

Various Vaping Modes with 75W Output

Despite the compact size, the iStick Pico RESIN still allows an intelligent but yet satisfying draw with 75W maximum output and switchable VW/Bypass/TC(Ni,Ti,SS,TCR) modes.

Single Replaceable 18650 Cell

Users can carry spare cells when on the go and change the cell easily by removing the battery cap.

Unique Bottom Design

The ventilation holes at the bottom are for better heat dissipation and the adjustment buttons are located at the bottom as well.

510 Spring Connector

It also retains stainless steel spring loaded 510 connector for strong wear resistance and high adaptability.

Functions of Micro USB Port

Charging: The 18650 cell can be charged in the iStick Pico RESIN through the side USB port via 1A wall adapter or computer or charged with an external battery charger. The recommended way is to charge the cell externally as it will take less time to give the cell a full charge.

Firmware upgrading: The firmware can be upgraded by connecting the device with a computer through the USB port via a micro USB cable.